Request for Modification of PicoFlasher.UF2 to Support Raspberry Pi Pico Clone YD-RP2040

[teslaweiler]

Dear balika011,

I hope this message finds you well.

I am reaching out to kindly request your assistance with modifying the PicoFlasher.UF2 file to ensure compatibility with a Raspberry Pi Pico clone, the YD-RP2040 by VCC-GND. I have attached the schematic and specifications of the YD-RP2040 for your reference.

Your expertise in this area is highly respected, and I believe your efforts would be invaluable in helping this project succeed. Any assistance you could provide would be greatly appreciated.

Thank you very much for considering my request. I look forward to your response and any guidance you may offer.

Best regards,

VCC-GND Studios’ YD-RP2040 has the following improvements over the Raspberry Pi Pico:

Added PWR power LED
The USB interface was changed to type-C USB
Added reset button to facilitate reset operation and firmware update operation
Added the USRkey user button (GPIO24)
Added RGB lights (GPIO23)
Change PICO’s W25Q16 to W25Q32 (4M) / W25Q64 (8M) / W25Q128 (16M)

YD-2040-2022-V1.1-SCH.pdf