Not all parts are duplicated when changing pattern length

[Ugg101]

I haven’t tested extensively yet, but it seems some parts don’t copy to the new bars when changing a pattern’s length from 1 or 2 bars to 4 bars. Normal behavior is when starting out with a one or two bar pattern, changing the length will copy all the data in the original bars over to the new ones. This was the case with my grey E2 with the factory firmware and the hacked sampler firmware. Has anyone else noticed the issue with the Hacktribe?

[bangcorrupt]

This behaves differently if the pattern has already been saved at the longer length, it won't overwrite those steps even if they are deleted first. From an initialised pattern saved at 1 bar length, it should always populate all parts. If you can provide steps to reproduce showing it doesn't work like this in Hacktribe I will look into this further.

[Ugg101]

You're probably right, although I could have sworn I started from a clean init pattern. I'll leave the discussion open until I can investigate further.

Thanks so much for your fine work with Hacktribe!