error after update

[lidas1234]

Hi I did an update of my display TFT35 V3, but now every now and then I find myself this error and solve it by turning off the printer and turning it back on, do you have any ideas to advise me to do
Thanks

[oldman4U]

What happens when you press Confirm?

Do you have a filament sensor attached?

Have you tried to remove the TFT from the enclosure it is mounted to?

[lidas1234]

Nothing happens when I press Confirm I have a filament sensor connected I have not tried to remove the TFT from the case it is mounted on

…

Il giorno 23 mar 2021, alle ore 19:11, oldman4U ***@***.***> ha scritto: What happens when you press Confirm? Do you have a filament sensor attached? Have you tried to remove the TFT from the enclosure it is mounted to? — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#1759 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AMXMQE647WFHZIVWZZJJGMTTFDKT3ANCNFSM4ZR3HTRA>.

[oldman4U]

What happens when you press Pause during a print?

I would check that you have all functions enabled in Marlin which are mentioned in config.ini and use a Marlin nightly build. Most likely you can resume the print after that.

Remove the screen to see if the problem itself is solved then.

[oldman4U]

Remove the display from the enclosure.

Make sure you have Marlin configured according to what's written in config.ini.

If this doesn't help remove the sensor physically and from firmware.

[oldman4U]

Any news?