HomeAssistant Errors using 2 coral's for detecting #3851
Unanswered
Engine1992
asked this question in
Ask A Question
Replies: 1 comment
-
|
I see a lot of camera errors but also detection getting stuck, I'd start by looking at HASS issues but might be proxmox as well |
Beta Was this translation helpful? Give feedback.
0 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Uh oh!
There was an error while loading. Please reload this page.
Uh oh!
There was an error while loading. Please reload this page.
-
Hi.
I have the Frigate add-on installed on HomeAssistant. HomeAssistant relies on VM Proxmox. I have two TPU Coral coprocessors connected to the server.
After starting Frigate, everything runs for about 30 minutes, detection is ok, no errors. After 30 minutes, it starts flooding with errors in the HomeAssistant console and in Frigate logs. Sometimes Frigate reconnects the Coral processors and everything goes back to normal for a while and then crashes again, and sometimes Frigate turns off completely. I attach screenshots from the HomeAssistant console, Proxmox console (coprocessors are detected all the time) and Frigate logs. I read that it may be a problem with the linux kernel version HomeAssistant is on - go in that direction or look elsewhere? Honestly, I start to run out of ideas what to do with it.
HomeAssistant Console:
Proxmox "lsusb":
Frigate logs:
Beta Was this translation helpful? Give feedback.
All reactions