Results
The hot plate heats up fine but stays hot even after turned off completely, making it impossible to cool down on its own at a reasonable rate. This is due to the thermal mass of the plate which makes the plate retain heat even when the power is cut. Below shows a reflow curve that was collected using the Excel HID keyboard feature in the Reflowduino Demo code. The starting temperature was a bit high because I hadn't waited for the plate to cool down (yes, it takes a very long time!) after a previous use. The preheat temperature was set to 50°C, soak set to 80°C, and reflow set to 100°C for testing purposes. The rates of change were set to 2°C/s for preheat, 0.7°C/s for preheat, 2°C/s for reflow, and -4°C/s for cooldown.
As seen from the data, the temperature actually overshot past 100°C to about 113°C. The rate of temperature increase seemed to be a mere 0.46°C/s increase all the way up to the reflow temperature. The rate of temperature decrease was a teeny tiny 0.08°C/s (very slow!!!). Additionally, the following graph of the hot plate turned to HIGH and directly plugged in (without being controlled by the Reflowduino) indicates that this 0.46°C/s increase is the best the hot plate can do:
(As you can see, I didn't bother waiting a day for it to cool back down...) This data proves that this particular hot plate is not suitable for reflow because of its inability to heat up quickly and cool down quickly due to high thermal inertia. For cooking ramen noodles this might be OK, but for us this is a big no no. However, if you end up with a hot plate that exhibits similar thermal characteristics, one thing you might consider doing is to factor in the 13°C overshoot and subtract it from the desired reflow temperature. Although it takes a while to heat up and cool down, you would likely still get a decent reflow job done, just much slower (especially the cooling part). For example, after reflow you might want to consider using a pair of tweezers to carefully move the PCB onto another surface to cool instead of waiting an hour for the plate to cool.
The toaster oven results were much better than the hot plate, mainly because of more responsive heating and cooling compared to the laggy hot plate with high thermal inertia. This contributed to extremely nice reflow curves like the one shown below!
[[]]