update TODO and README notes

no known issues!

Author: bsstephan

README.md

@@ -43,13 +43,7 @@ What you'll need beyond these objects:
 
 ### Issues and Limitations
 
-This is a living repository, and as such, there are likely issues with the objects, known or otherwise. Be aware:
-
-* A composition error made the frame 5mm shorter than intended and wasn't noticed until I printed everything:
-    * Some levers don't have enough clearance in the case.
-    * Buttons with traditional quick connects are a *very* tight fit, you will probably need to bend pins.
-* The PCB mount position was very tight on the buttons panel; it will probably have to be moved.
-
+This is a living repository, and as such, there are likely issues with the objects, known or otherwise.
 These issues may be fixed in the future; see `TODO.md` for details.
 
 ## Development and Contributing

TODO.md

@@ -2,16 +2,6 @@
 
 Notes for "next time".
 
-## v2
-
-* I need at least 5mm, maybe 10mm, more height, to fit some of my levers like the Nobi Bullet
-    * I couldn't even fit a JLF without the compensations in v1 on the bottom panel
-    * I had to bend the pins a bit on Crown SDB-202s, too
-* The plates bow a bit on the top when pressure is applied, because there's no support from the frame up there ---
-  adding 5mm to the frame should leave a couple mm for support to get added back
-* PCB mount on `top-panel-dir_arc-plus-w-30mm-plus-one-with-mount.scad` doesn't leave room for a USB cable on the right
-  hand side
-
 ## v3
 
 * Check that the 24mm cutouts in the frame are good enough, somehow I didn't have them when I printed v2