drm/bridge: ti-sn65dsi86: Fix output polarity setting bug

According to the description in ti-sn65dsi86's datasheet:

CHA_HSYNC_POLARITY:
0 = Active High Pulse. Synchronization signal is high for the sync
pulse width. (default)
1 = Active Low Pulse. Synchronization signal is low for the sync
pulse width.

CHA_VSYNC_POLARITY:
0 = Active High Pulse. Synchronization signal is high for the sync
pulse width. (Default)
1 = Active Low Pulse. Synchronization signal is low for the sync
pulse width.

We should only set these bits when the polarity is negative.

Fixes: a095f15 ("drm/bridge: add support for sn65dsi86 bridge driver")
Signed-off-by: Qiqi Zhang <[email protected]>
Reviewed-by: Douglas Anderson <[email protected]>
Tested-by: Douglas Anderson <[email protected]>
Reviewed-by: Tomi Valkeinen <[email protected]>
Signed-off-by: Douglas Anderson <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]

Author: Qiqi Zhang

drivers/gpu/drm/bridge/ti-sn65dsi86.c

@@ -931,9 +931,9 @@ static void ti_sn_bridge_set_video_timings(struct ti_sn65dsi86 *pdata)
 		&pdata->bridge.encoder->crtc->state->adjusted_mode;
 	u8 hsync_polarity = 0, vsync_polarity = 0;
 
-	if (mode->flags & DRM_MODE_FLAG_PHSYNC)
+	if (mode->flags & DRM_MODE_FLAG_NHSYNC)
 		hsync_polarity = CHA_HSYNC_POLARITY;
-	if (mode->flags & DRM_MODE_FLAG_PVSYNC)
+	if (mode->flags & DRM_MODE_FLAG_NVSYNC)
 		vsync_polarity = CHA_VSYNC_POLARITY;
 
 	ti_sn65dsi86_write_u16(pdata, SN_CHA_ACTIVE_LINE_LENGTH_LOW_REG,