diff --git a/src/content/docs/magic-wan/configuration/connector/configure-hardware-connector/index.mdx b/src/content/docs/magic-wan/configuration/connector/configure-hardware-connector/index.mdx
index b3ad2d84bad0e5e..9a4fc9f4e28293a 100644
--- a/src/content/docs/magic-wan/configuration/connector/configure-hardware-connector/index.mdx
+++ b/src/content/docs/magic-wan/configuration/connector/configure-hardware-connector/index.mdx
@@ -149,6 +149,7 @@ Make sure you complete the setup workflow and activate your Magic WAN Connector
 <Render
 	file="connector/ha-configs"
 	params={{
+		hardSoftConn: "You need to deploy two Connectors in your premises before you can set up a site in high availability.",
 		finalInstructions:
 			"Follow the instructions in [Set up your Magic WAN Connector](#set-up-your-magic-wan-connector) and [Activate connector](#activate-connector) to finish setting up your Connectors.",
 	}}
diff --git a/src/content/docs/magic-wan/configuration/connector/configure-virtual-connector.mdx b/src/content/docs/magic-wan/configuration/connector/configure-virtual-connector.mdx
index adf7ec7def86695..5c0a8263f9b44da 100644
--- a/src/content/docs/magic-wan/configuration/connector/configure-virtual-connector.mdx
+++ b/src/content/docs/magic-wan/configuration/connector/configure-virtual-connector.mdx
@@ -157,6 +157,7 @@ Make sure you complete the setup workflow and activate your Virtual Connector be
 <Render
 	file="connector/ha-configs"
 	params={{
+		hardSoftConn: "You need to install two Virtual Connectors before you can set up a site in high availability.",
 		finalInstructions:
 			"Follow the instructions in [Activate connector](#activate-connector) to finish setting up your Connectors.",
 	}}
diff --git a/src/content/partials/magic-wan/connector/ha-configs.mdx b/src/content/partials/magic-wan/connector/ha-configs.mdx
index b216c180584d51f..1d1c42dafc678d5 100644
--- a/src/content/partials/magic-wan/connector/ha-configs.mdx
+++ b/src/content/partials/magic-wan/connector/ha-configs.mdx
@@ -1,13 +1,14 @@
 ---
 params:
   - finalInstructions
+  - hardSoftConn
 ---
 
 import { Markdown } from "~/components";
 
 ## About high availability configurations
 
-When you set up a site in high availability, the WANs and LANs in your Connectors have the same configuration but are replicated on two nodes. In case of failure of a Connector, the other Connector becomes the active node, taking over configuration of the LAN gateway IP and allowing traffic to continue without disruption.
+{props.hardSoftConn} When you set up a site in high availability, the WANs and LANs in your Connectors have the same configuration but are replicated on two nodes. In case of failure of a Connector, the other Connector becomes the active node, taking over configuration of the LAN gateway IP and allowing traffic to continue without disruption.
 
 Because Connectors in high availability configurations share a single site, you need to set up: