Cannot record tracking data

[Peaj]

Describe the bug
When running the command .\survive-cli.exe --record 2024-12-19_tracking.rec.gz it only runs for about two seconds before it quits and the log file only contains basic info:

"v":"0",
"poser":"MPFIT",
"disambiguator":"StateBased",
"configed-lighthouse-gen":"1",
"ootx-ignore-sync-error":"0",
"floor-offset":"-0.034198313951"

Data
This is the log from runninng survive-cli without recording:

.\survive-cli.exe
Info: Adding tracked object WM0 from HTC
Info: All enumerated devices attached.
Info: Loaded drivers: GlobalSceneSolver, HTCVive
Warning: Config request failed; trying again 3.262485 WM0 (1865 > 1617)
Info: Device WM0 has watchman FW version 1498808359 and FPGA version 262/0/0; named '                  htcvrsoftware'. Hardware id 0x84010004 Board rev: 129 (len 65)
Info: Detected LH gen 1 system.
Info: Disambiguator is in 60hz mode (mode A)
Info: Locked onto state  2( 3,   259971) at    659490845 for WM0
Info: OOTX not set for LH 0; attaching ootx decoder using device WM0
Info: MPFIT success 1203908.430381/5257.9960706528/0.0018027 (19 measurements, 1, MP_OK_CHI, 194 iters, up err 0.0210036, trace 0.0003140)
Info: Global solve with 1 scenes for 0 with error of 1203908.430381/5257.9960706528 (acc err 0.0190)
Info: Using LH 0 (3d74fc7e) as reference lighthouse
Info: Adding lighthouse ch 1 (cnt: 2)
Info: OOTX not set for LH 1; attaching ootx decoder using device WM0
Warning: Too many failures for WM0 at 41.095291; reseting calibration 2.848711e-01 ( 0.0000 stationary)
Warning: Too many failures for WM0 at 43.668935; reseting calibration 1.599395e+03 ( 0.0000 stationary)
Warning: Too many failures for WM0 at 43.726149; reseting calibration 0.000000e+00 ( 0.0000 stationary)
Warning: Too many failures for WM0 at 43.944908; reseting calibration 1.553793e+00 ( 0.0000 stationary)
Warning: Too many failures for WM0 at 44.038934; reseting calibration 0.000000e+00 ( 0.0000 stationary)
Warning: Too many failures for WM0 at 44.105311; reseting calibration 0.000000e+00 ( 0.0000 stationary)
Warning: Too many failures for WM0 at 44.105911; reseting calibration 0.000000e+00 ( 0.0000 stationary)

Hardware setup
Single Lighthouse v1
HTC Tracker

Desktop (please complete the following information):

• OS: Windows
• Version: 11

Additional context
I also have severe tracking issues that I am trying to record but recording does not seem to work.