AdGuard LXC doesn't run properly after installation, only displays apache test page

[frozen-cdn]

Hello all, going insane here and have no idea what is wrong.

I simply installed the adguard LXC using the bash command, and went through the steps, assigned it it's static IP address with no problems, it updated itself and everything completed okay. Then, it asks me to connect via web browser to port :3000 which I did with no issues again, but as soon as that completes, adguard is no longer reachable?

Entering 192.168.1.2 into the web browser with no :3000 on the end simply displays the apache2 "It Works!" test page. And port 3000 is now completely offline, I get connection refused from this point on in the web browser

So therefore I cannot configure anything at all, or reach adguard whatsoever

root@adguard:~# systemctl status AdGuardHome
● AdGuardHome.service - AdGuard Home: Network-level blocker
     Loaded: loaded (/etc/systemd/system/AdGuardHome.service; enabled; preset: enabled)
     Active: active (running) since Thu 2025-03-20 13:50:54 EDT; 26s ago
   Main PID: 134 (AdGuardHome)
      Tasks: 7 (limit: 18830)
     Memory: 50.2M
        CPU: 335ms
     CGroup: /system.slice/AdGuardHome.service
             └─134 /opt/AdGuardHome/AdGuardHome -s run

Mar 20 13:50:54 adguard systemd[1]: Started AdGuardHome.service - AdGuard Home: Network-level blocker.

root@adguard:~# telnet 192.168.1.2 80
Trying 192.168.1.2...
Connected to 192.168.1.2.
Escape character is '^]'.
^C
Connection closed by foreign host.
root@adguard:~# telnet 192.168.1.2 3000
Trying 192.168.1.2...
telnet: Unable to connect to remote host: Connection refused
root@adguard:~# 

I'm puzzled, I have no idea what to do from this point on

Any help would be greatly appreciated thank you

[tremor021]

huh? why are you trying to telnet?

[frozen-cdn]

To see if there's anything listening on the port.

3000 is supposed to be the listen port for AdGuard.

[jwgn]

To see if there's anything listening on the port.

You can use ss -tulpn to see listening ports.

[tremor021]

sorry i can't reproduce your problem. works fine here

[frozen-cdn]

Hello, I already described this in my original post.

It fails after that stage.

[tremor021]

I forgot to paste the final screenshot

[MickLesk]

3000 is for install, after sucessfully install the port is unneeded.

Deployed now. Open with port 3000, click setup until finished.

[frozen-cdn]

Thanks, I figured this as well - but after the install stage and accessing on port 80 it just shows apache2 "It Works!" page

[MickLesk]

then try again, maybe you failed something in setup step 3

[frozen-cdn]

Will do, thank you MickLesk

[tremor021]

Make sure you listen on eth0, not on loopback adapter