ata: pata_parport: fit3: implement IDE command set registers

fit3 protocol driver does not support accessing IDE control registers
(device control/altstatus). The DOS driver does not use these registers
either (as observed from DOSEMU trace). But the HW seems to be capable
of accessing these registers - I simply tried bit 3 and it works!

The control register is required to properly reset ATAPI devices or
they will be detected only once (after a power cycle).

Tested with EXP Computer CD-865 with MC-1285B EPP cable and
TransDisk 3000.

Signed-off-by: Ondrej Zary <[email protected]>
Reviewed-by: Sergey Shtylyov <[email protected]>
Signed-off-by: Damien Le Moal <[email protected]>

Author: Ondrej Zary

drivers/ata/pata_parport/fit3.c

@@ -9,11 +9,6 @@
  *
  * The TD-2000 and certain older devices use a different protocol.
  * Try the fit2 protocol module with them.
- *
- * NB:  The FIT adapters do not appear to support the control
- * registers.  So, we map ALT_STATUS to STATUS and NO-OP writes
- * to the device control register - this means that IDE reset
- * will not work on these devices.
  */
 
 #include <linux/module.h>
@@ -37,8 +32,7 @@
 
 static void fit3_write_regr(struct pi_adapter *pi, int cont, int regr, int val)
 {
-	if (cont == 1)
-		return;
+	regr += cont << 3;
 
 	switch (pi->mode) {
 	case 0:
@@ -59,11 +53,7 @@ static int fit3_read_regr(struct pi_adapter *pi, int cont, int regr)
 {
 	int  a, b;
 
-	if (cont) {
-		if (regr != 6)
-			return 0xff;
-		regr = 7;
-	}
+	regr += cont << 3;
 
 	switch (pi->mode) {
 	case 0: