Merge tag 'gpio-fixes-for-v6.10-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/brgl/linux

Pull gpio fixes from Bartosz Golaszewski:
 "An assortment of driver fixes and two commits addressing a bad
  behavior of the GPIO uAPI when reconfiguring requested lines.

   - fix a race condition in i2c transfers by adding a missing i2c lock
     section in gpio-pca953x

   - validate the number of obtained interrupts in gpio-davinci

   - add missing raw_spinlock_init() in gpio-graniterapids

   - fix bad character device behavior: disallow GPIO line
     reconfiguration without set direction both in v1 and v2 uAPI"

* tag 'gpio-fixes-for-v6.10-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/brgl/linux:
  gpiolib: cdev: Ignore reconfiguration without direction
  gpiolib: cdev: Disallow reconfiguration without direction (uAPI v1)
  gpio: graniterapids: Add missing raw_spinlock_init()
  gpio: davinci: Validate the obtained number of IRQs
  gpio: pca953x: fix pca953x_irq_bus_sync_unlock race

Author: torvalds

drivers/gpio/gpio-davinci.c

@@ -225,6 +225,11 @@ static int davinci_gpio_probe(struct platform_device *pdev)
 	else
 		nirq = DIV_ROUND_UP(ngpio, 16);
 
+	if (nirq > MAX_INT_PER_BANK) {
+		dev_err(dev, "Too many IRQs!\n");
+		return -EINVAL;
+	}
+
 	chips = devm_kzalloc(dev, sizeof(*chips), GFP_KERNEL);
 	if (!chips)
 		return -ENOMEM;

drivers/gpio/gpio-graniterapids.c

@@ -296,6 +296,8 @@ static int gnr_gpio_probe(struct platform_device *pdev)
 	if (!priv)
 		return -ENOMEM;
 
+	raw_spin_lock_init(&priv->lock);
+
 	regs = devm_platform_ioremap_resource(pdev, 0);
 	if (IS_ERR(regs))
 		return PTR_ERR(regs);

drivers/gpio/gpio-pca953x.c

@@ -758,6 +758,8 @@ static void pca953x_irq_bus_sync_unlock(struct irq_data *d)
 	int level;
 
 	if (chip->driver_data & PCA_PCAL) {
+		guard(mutex)(&chip->i2c_lock);
+
 		/* Enable latch on interrupt-enabled inputs */
 		pca953x_write_regs(chip, PCAL953X_IN_LATCH, chip->irq_mask);
 

drivers/gpio/gpiolib-cdev.c

@@ -89,6 +89,10 @@ struct linehandle_state {
 	GPIOHANDLE_REQUEST_OPEN_DRAIN | \
 	GPIOHANDLE_REQUEST_OPEN_SOURCE)
 
+#define GPIOHANDLE_REQUEST_DIRECTION_FLAGS \
+	(GPIOHANDLE_REQUEST_INPUT | \
+	 GPIOHANDLE_REQUEST_OUTPUT)
+
 static int linehandle_validate_flags(u32 flags)
 {
 	/* Return an error if an unknown flag is set */
@@ -169,21 +173,21 @@ static long linehandle_set_config(struct linehandle_state *lh,
 	if (ret)
 		return ret;
 
+	/* Lines must be reconfigured explicitly as input or output. */
+	if (!(lflags & GPIOHANDLE_REQUEST_DIRECTION_FLAGS))
+		return -EINVAL;
+
 	for (i = 0; i < lh->num_descs; i++) {
 		desc = lh->descs[i];
-		linehandle_flags_to_desc_flags(gcnf.flags, &desc->flags);
+		linehandle_flags_to_desc_flags(lflags, &desc->flags);
 
-		/*
-		 * Lines have to be requested explicitly for input
-		 * or output, else the line will be treated "as is".
-		 */
 		if (lflags & GPIOHANDLE_REQUEST_OUTPUT) {
 			int val = !!gcnf.default_values[i];
 
 			ret = gpiod_direction_output(desc, val);
 			if (ret)
 				return ret;
-		} else if (lflags & GPIOHANDLE_REQUEST_INPUT) {
+		} else {
 			ret = gpiod_direction_input(desc);
 			if (ret)
 				return ret;
@@ -1530,20 +1534,22 @@ static long linereq_set_config(struct linereq *lr, void __user *ip)
 		line = &lr->lines[i];
 		desc = lr->lines[i].desc;
 		flags = gpio_v2_line_config_flags(&lc, i);
-		gpio_v2_line_config_flags_to_desc_flags(flags, &desc->flags);
-		edflags = flags & GPIO_V2_LINE_EDGE_DETECTOR_FLAGS;
 		/*
-		 * Lines have to be requested explicitly for input
-		 * or output, else the line will be treated "as is".
+		 * Lines not explicitly reconfigured as input or output
+		 * are left unchanged.
 		 */
+		if (!(flags & GPIO_V2_LINE_DIRECTION_FLAGS))
+			continue;
+		gpio_v2_line_config_flags_to_desc_flags(flags, &desc->flags);
+		edflags = flags & GPIO_V2_LINE_EDGE_DETECTOR_FLAGS;
 		if (flags & GPIO_V2_LINE_FLAG_OUTPUT) {
 			int val = gpio_v2_line_config_output_value(&lc, i);
 
 			edge_detector_stop(line);
 			ret = gpiod_direction_output(desc, val);
 			if (ret)
 				return ret;
-		} else if (flags & GPIO_V2_LINE_FLAG_INPUT) {
+		} else {
 			ret = gpiod_direction_input(desc);
 			if (ret)
 				return ret;