iio: adc: add support for Nuvoton NCT7201

Add Nuvoton NCT7201/NCT7202 system voltage monitor 12-bit ADC driver

NCT7201/NCT7202 supports up to 12 analog voltage monitor inputs and up
to 4 SMBus addresses by ADDR pin. Meanwhile, ALERT# hardware event pins
for independent alarm signals, and all the threshold values could be set
for system protection without any timing delay. It also supports reset
input RSTIN# to recover system from a fault condition.

Currently, only single-edge mode conversion and threshold events are
supported.

Signed-off-by: Eason Yang <[email protected]>
Reviewed-by: Andy Shevchenko <[email protected]>
Link: https://patch.msgid.link/[email protected]
Signed-off-by: Jonathan Cameron <[email protected]>

Author: YHYANG2

MAINTAINERS

@@ -17341,6 +17341,7 @@ M:	Eason Yang <[email protected]>
 L:	[email protected]
 S:	Maintained
 F:	Documentation/devicetree/bindings/iio/adc/nuvoton,nct7201.yaml
+F:	drivers/iio/adc/nct7201.c
 
 NVIDIA (rivafb and nvidiafb) FRAMEBUFFER DRIVER
 M:	Antonino Daplas <[email protected]>

drivers/iio/adc/Kconfig

@@ -1103,6 +1103,17 @@ config NAU7802
 	  To compile this driver as a module, choose M here: the
 	  module will be called nau7802.
 
+config NCT7201
+	tristate "Nuvoton Instruments NCT7201 and NCT7202 Power Monitor"
+	depends on I2C
+	select REGMAP_I2C
+	help
+	  If you say yes here you get support for the Nuvoton NCT7201 and
+	  NCT7202 Voltage Monitor.
+
+	  This driver can also be built as a module. If so, the module
+	  will be called nct7201.
+
 config NPCM_ADC
 	tristate "Nuvoton NPCM ADC driver"
 	depends on ARCH_NPCM || COMPILE_TEST

drivers/iio/adc/Makefile

@@ -99,6 +99,7 @@ obj-$(CONFIG_MESON_SARADC) += meson_saradc.o
 obj-$(CONFIG_MP2629_ADC) += mp2629_adc.o
 obj-$(CONFIG_MXS_LRADC_ADC) += mxs-lradc-adc.o
 obj-$(CONFIG_NAU7802) += nau7802.o
+obj-$(CONFIG_NCT7201) += nct7201.o
 obj-$(CONFIG_NPCM_ADC) += npcm_adc.o
 obj-$(CONFIG_PAC1921) += pac1921.o
 obj-$(CONFIG_PAC1934) += pac1934.o