scsi: pm80xx: Use phy-specific SAS address when sending PHY_START command

Some cards have more than one SAS address. Using an incorrect address
causes communication issues with some devices like expanders.

Closes: https://lore.kernel.org/linux-kernel/[email protected]/
Signed-off-by: Michal Grzedzicki <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Acked-by: Jack Wang <[email protected]>
Signed-off-by: Martin K. Petersen <[email protected]>

Author: Michal Grzedzicki

drivers/scsi/pm8001/pm8001_hwi.c

@@ -4180,7 +4180,7 @@ pm8001_chip_phy_start_req(struct pm8001_hba_info *pm8001_ha, u8 phy_id)
 	payload.sas_identify.dev_type = SAS_END_DEVICE;
 	payload.sas_identify.initiator_bits = SAS_PROTOCOL_ALL;
 	memcpy(payload.sas_identify.sas_addr,
-		pm8001_ha->sas_addr, SAS_ADDR_SIZE);
+		&pm8001_ha->phy[phy_id].dev_sas_addr, SAS_ADDR_SIZE);
 	payload.sas_identify.phy_id = phy_id;
 
 	return pm8001_mpi_build_cmd(pm8001_ha, 0, opcode, &payload,

drivers/scsi/pm8001/pm80xx_hwi.c

@@ -4671,7 +4671,7 @@ pm80xx_chip_phy_start_req(struct pm8001_hba_info *pm8001_ha, u8 phy_id)
 	payload.sas_identify.dev_type = SAS_END_DEVICE;
 	payload.sas_identify.initiator_bits = SAS_PROTOCOL_ALL;
 	memcpy(payload.sas_identify.sas_addr,
-	  &pm8001_ha->sas_addr, SAS_ADDR_SIZE);
+		&pm8001_ha->phy[phy_id].dev_sas_addr, SAS_ADDR_SIZE);
 	payload.sas_identify.phy_id = phy_id;
 
 	return pm8001_mpi_build_cmd(pm8001_ha, 0, opcode, &payload,