ata: libata-eh: Do not use ATAPI DMA for a device limited to PIO mode

atapi_eh_request_sense() currently uses ATAPI DMA if the SATA controller
has ATA_FLAG_PIO_DMA (PIO cmds via DMA) set.

However, ATA_FLAG_PIO_DMA is a flag that can be set by a low-level driver
on a port at initialization time, before any devices are scanned.

If a controller detects a connected device that only supports PIO, we set
the flag ATA_DFLAG_PIO.

Modify atapi_eh_request_sense() to not use ATAPI DMA if the connected
device only supports PIO.

Reported-by: Philip Pemberton <[email protected]>
Closes: https://lore.kernel.org/linux-ide/[email protected]/
Tested-by: Philip Pemberton <[email protected]>
Reviewed-by: Damien Le Moal <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Signed-off-by: Niklas Cassel <[email protected]>

Author: floatious

drivers/ata/libata-eh.c

@@ -1542,8 +1542,15 @@ unsigned int atapi_eh_request_sense(struct ata_device *dev,
 	tf.flags |= ATA_TFLAG_ISADDR | ATA_TFLAG_DEVICE;
 	tf.command = ATA_CMD_PACKET;
 
-	/* is it pointless to prefer PIO for "safety reasons"? */
-	if (ap->flags & ATA_FLAG_PIO_DMA) {
+	/*
+	 * Do not use DMA if the connected device only supports PIO, even if the
+	 * port prefers PIO commands via DMA.
+	 *
+	 * Ideally, we should call atapi_check_dma() to check if it is safe for
+	 * the LLD to use DMA for REQUEST_SENSE, but we don't have a qc.
+	 * Since we can't check the command, perhaps we should only use pio?
+	 */
+	if ((ap->flags & ATA_FLAG_PIO_DMA) && !(dev->flags & ATA_DFLAG_PIO)) {
 		tf.protocol = ATAPI_PROT_DMA;
 		tf.feature |= ATAPI_PKT_DMA;
 	} else {