irqchip/ocelot: Fix trigger register address

Controllers, supported by this driver, have two sets of registers:

 * (main) interrupt registers control peripheral interrupt sources.

 * device interrupt registers configure per-device (network interface)
   interrupts and act as an extra stage before the main interrupt
   registers.

In the driver unmask code, device trigger registers are used in the mask
calculation of the main interrupt sticky register, mixing two kinds of
registers.

Use the main interrupt trigger register instead.

Signed-off-by: Sergey Matsievskiy <[email protected]>
Signed-off-by: Thomas Gleixner <[email protected]>
Link: https://lore.kernel.org/all/[email protected]

Author: Sergey Matsievskiy

drivers/irqchip/irq-mscc-ocelot.c

@@ -37,7 +37,7 @@ static struct chip_props ocelot_props = {
 	.reg_off_ena_clr	= 0x1c,
 	.reg_off_ena_set	= 0x20,
 	.reg_off_ident		= 0x38,
-	.reg_off_trigger	= 0x5c,
+	.reg_off_trigger	= 0x4,
 	.n_irq			= 24,
 };
 
@@ -70,7 +70,7 @@ static struct chip_props jaguar2_props = {
 	.reg_off_ena_clr	= 0x1c,
 	.reg_off_ena_set	= 0x20,
 	.reg_off_ident		= 0x38,
-	.reg_off_trigger	= 0x5c,
+	.reg_off_trigger	= 0x4,
 	.n_irq			= 29,
 };