regmap: Move selecting for REGMAP_MDIO and REGMAP_IRQ

If either REGMAP_IRQ or REGMAP_MDIO are set then REGMAP is also set.
This then enables the selecting of IRQ_DOMAIN or MDIO_BUS from REGMAP
based on the above two symbols respectively. This makes it very easy
to end up with "circular dependencies".

Instead select the IRQ_DOMAIN or MDIO_BUS from the symbols that make
use of them. This is almost equivalent to before but makes it less
likely to end up with false circular dependency detections.

Signed-off-by: Andrew Davis <[email protected]>
Reported-by: Krzysztof Kozlowski <[email protected]>
Closes: https://lore.kernel.org/r/[email protected]/
Reviewed-by: Krzysztof Kozlowski <[email protected]>
Link: https://patch.msgid.link/[email protected]
Signed-off-by: Mark Brown <[email protected]>

Author: glneo

drivers/base/regmap/Kconfig

@@ -6,8 +6,6 @@
 config REGMAP
 	bool
 	default y if (REGMAP_I2C || REGMAP_SPI || REGMAP_SPMI || REGMAP_W1 || REGMAP_AC97 || REGMAP_MMIO || REGMAP_IRQ || REGMAP_SOUNDWIRE || REGMAP_SOUNDWIRE_MBQ || REGMAP_SCCB || REGMAP_I3C || REGMAP_SPI_AVMM || REGMAP_MDIO || REGMAP_FSI)
-	select IRQ_DOMAIN if REGMAP_IRQ
-	select MDIO_BUS if REGMAP_MDIO
 	help
 	  Enable support for the Register Map (regmap) access API.
 
@@ -58,12 +56,14 @@ config REGMAP_W1
 
 config REGMAP_MDIO
 	tristate
+	select MDIO_BUS
 
 config REGMAP_MMIO
 	tristate
 
 config REGMAP_IRQ
 	bool
+	select IRQ_DOMAIN
 
 config REGMAP_RAM
 	tristate