scsi: ufs: exynos: gs101: Put UFS device in reset on .suspend()

GPIO_OUT[0] is connected to the reset pin of embedded UFS device.
Before powering off the phy assert the reset signal.

This is added as a gs101 specific suspend hook so as not to have any
unintended consequences for other SoCs supported by this driver.

Signed-off-by: Peter Griffin <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Reviewed-by: Bart Van Assche <[email protected]>
Signed-off-by: Martin K. Petersen <[email protected]>

Author: petegriffin

drivers/ufs/host/ufs-exynos.c

@@ -1700,6 +1700,12 @@ static void exynos_ufs_hibern8_notify(struct ufs_hba *hba,
 	}
 }
 
+static int gs101_ufs_suspend(struct exynos_ufs *ufs)
+{
+	hci_writel(ufs, 0 << 0, HCI_GPIO_OUT);
+	return 0;
+}
+
 static int exynos_ufs_suspend(struct ufs_hba *hba, enum ufs_pm_op pm_op,
 	enum ufs_notify_change_status status)
 {
@@ -1708,6 +1714,9 @@ static int exynos_ufs_suspend(struct ufs_hba *hba, enum ufs_pm_op pm_op,
 	if (status == PRE_CHANGE)
 		return 0;
 
+	if (ufs->drv_data->suspend)
+		ufs->drv_data->suspend(ufs);
+
 	if (!ufshcd_is_link_active(hba))
 		phy_power_off(ufs->phy);
 
@@ -2170,6 +2179,7 @@ static const struct exynos_ufs_drv_data gs101_ufs_drvs = {
 	.pre_link		= gs101_ufs_pre_link,
 	.post_link		= gs101_ufs_post_link,
 	.pre_pwr_change		= gs101_ufs_pre_pwr_change,
+	.suspend		= gs101_ufs_suspend,
 };
 
 static const struct of_device_id exynos_ufs_of_match[] = {

drivers/ufs/host/ufs-exynos.h

@@ -192,6 +192,7 @@ struct exynos_ufs_drv_data {
 				struct ufs_pa_layer_attr *pwr);
 	int (*pre_hce_enable)(struct exynos_ufs *ufs);
 	int (*post_hce_enable)(struct exynos_ufs *ufs);
+	int (*suspend)(struct exynos_ufs *ufs);
 };
 
 struct ufs_phy_time_cfg {