gpio: bcm-kona: Fix GPIO lock/unlock for banks above bank 0

The GPIO lock/unlock functions clear/write a bit to the relevant
register for each bank. However, due to an oversight the bit that
was being written was based on the total GPIO number, not the index
of the GPIO within the relevant bank, causing it to fail for any
GPIO above 32 (thus any GPIO for banks above bank 0).

Fix lock/unlock for these banks by using the correct bit.

Fixes: bdb93c0 ("gpio: bcm281xx: Centralize register locking")
Reviewed-by: Florian Fainelli <[email protected]>
Reviewed-by: Markus Mayer <[email protected]>
Signed-off-by: Artur Weber <[email protected]>
Reviewed-by: Linus Walleij <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Signed-off-by: Bartosz Golaszewski <[email protected]>

Author: refractionware

drivers/gpio/gpio-bcm-kona.c

@@ -86,11 +86,12 @@ static void bcm_kona_gpio_lock_gpio(struct bcm_kona_gpio *kona_gpio,
 	u32 val;
 	unsigned long flags;
 	int bank_id = GPIO_BANK(gpio);
+	int bit = GPIO_BIT(gpio);
 
 	raw_spin_lock_irqsave(&kona_gpio->lock, flags);
 
 	val = readl(kona_gpio->reg_base + GPIO_PWD_STATUS(bank_id));
-	val |= BIT(gpio);
+	val |= BIT(bit);
 	bcm_kona_gpio_write_lock_regs(kona_gpio->reg_base, bank_id, val);
 
 	raw_spin_unlock_irqrestore(&kona_gpio->lock, flags);
@@ -102,11 +103,12 @@ static void bcm_kona_gpio_unlock_gpio(struct bcm_kona_gpio *kona_gpio,
 	u32 val;
 	unsigned long flags;
 	int bank_id = GPIO_BANK(gpio);
+	int bit = GPIO_BIT(gpio);
 
 	raw_spin_lock_irqsave(&kona_gpio->lock, flags);
 
 	val = readl(kona_gpio->reg_base + GPIO_PWD_STATUS(bank_id));
-	val &= ~BIT(gpio);
+	val &= ~BIT(bit);
 	bcm_kona_gpio_write_lock_regs(kona_gpio->reg_base, bank_id, val);
 
 	raw_spin_unlock_irqrestore(&kona_gpio->lock, flags);