Question about test set

[namtranlab]

Hi Everyone,

I checked the forum that #217 If I have a system with a number of sets in the training_data, the last set is used as testing data. Does it mean that the last set will not be used during the training?

If this is the case, should we have the data of RSME for this test set in the output? I only found the data for the validation set in the output. I see in some publications plotting the evolution of RSME on the test set during the training. It is the data for the validation set in the output, isn't it?

Also, It seems that the command dp test only picks the data of the last set in a system? I tried to change the value of -n NUMBER but it seems not working.

Best regards

[njzjz]

This behavior has been deprecated since v2.0.0.