Wifi connection?
#485
Replies: 1 comment 1 reply
-
|
If you wait a few minutes, it will end up in hotspot mode automatically
You can also reset the firmware with these steps:
Disconnect the power
Press and hold both shifter buttons
Reconnect the power
Wait 3 seconds
Release the buttons.
This should reset the firmware
…On Mon, Oct 9, 2023, 7:18 p.m. Manlio Lo Conte ***@***.***> wrote:
Hey, i started setting up my smartspin today and i saw the WAP show up on
initial power up, but then i fat-fingered the password to my home wifi
network (i know, i know). I haven't been able to get the WAP to show up
again since then, the device powers, and then the LED starts blinking red,
nothing shows up in wifi settings. Is there a way to perform a reset and
start the process again? Thanks in advance.
—
Reply to this email directly, view it on GitHub
<#485>, or unsubscribe
<https://github.com/notifications/unsubscribe-auth/AF4U2PGYFU4VOZVDTVJNPKDX6SA5FAVCNFSM6AAAAAA5ZOUKAKVHI2DSMVQWIX3LMV43ERDJONRXK43TNFXW4OZVG4YTSMRSGY>
.
You are receiving this because you are subscribed to this thread.Message
ID: ***@***.***>
|
Beta Was this translation helpful? Give feedback.
1 reply
Answer selected by
doudar
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Uh oh!
There was an error while loading. Please reload this page.
-
Hey, i started setting up my smartspin today and i saw the WAP show up on initial power up, but then i fat-fingered the password to my home wifi network (i know, i know). I haven't been able to get the WAP to show up again since then, the device powers, and then the LED starts blinking red, nothing shows up in wifi settings. Is there a way to perform a reset and start the process again? Thanks in advance.
Beta Was this translation helpful? Give feedback.
All reactions