Don't Understand How to Upgrade Firmware on myCobot280 Raspberry Pi

[michelle-aa-robotics-photonics]

I'm trying to upgrade Atom on myCobot 280 Pi through myStudio and I can't seem to flash the firmware because I get an error saying I need to connect my machine. However, I'm literally running this on a Raspberry Pi connected to an external monitor. As far as I know, the myCobot 280 cannot be hooked up to an external PC (if you want to use another computer, you need to use VNC). So how do I flash a firmware update on to my cobot 280 Pi?

[n7729697]

You need another computer to flash it, connect the computer to the type-c port at the tool_base (arm top), then install the driver for M5 (You could find them in the download page of resources). After successfully install the driver on the computer, you also need a myStuio software to flash the M5 board. After installatioin, just burning the firmware to the arm. It should works fine.

You could also connect the M5 atom (tool_base) using type-c to USB with the raspberry pi to flash it.