STM32H747I Disco Board

[stanleycelestin1]

Will this repo work for the STM32H747I Disco Board?

If not, what work flow do you suggest for the STM32H747I Disco Board?

I am new to STM32 and would like any guidance. I find the resources from STM to be all over the place.

Any help will be appreciated.

[elmot]

I believe I have a better solution
Check this gist instead
https://gist.github.com/elmot/c48f756c5443c4a003978db94392e00d

[stanleycelestin1]

Thank you @elmot. I was able to use that cmakelist but I am getting the same issue that I had using the the double cmake strategy:

After configuring the the debugger per the instructions on the readme I was unable to flash the project.

When I run/debug the CM4 I get this:

Can you help me understand what is causing that?

When I run/debug the CM7 I get this:

Can you help me understand what is causing Info : default port : 7184 Info : Remote address: 127.0.0.1 Info : stlinkserver already running, exit

For the CM7 project, I have toggle for LED4 with is on PI15:
HAL_GPIO_TogglePin(GPIOI, GPIO_PIN_15); HAL_Delay(500);

Is there something I am doing wrong here? I just want blink an LED to see the full dev cycle

[elmot]

Sorry I had to point you to the following comment with more details:
https://youtrack.jetbrains.com/issue/CPP-21014#focus=Comments-27-4534144.0-0