Monitor interface overview, creating monitor interfaces

CLI way

Monitor interface can be created on any phy since Linux always supports monitor interface mode in software, regardless of driver features on a given WiFi NIC. To create a monitor mode interface wlan0monitor0 on device phy0, use iw phy phy0 interface add wlan0monitor0 type monitor && ip link set wlan0monitor0 up. Resulting monitor mode can be used in wireshark to sniff packets.

Caveats

Your NIC may not support multiple modes at once. You can always see combinations supported by your NIC using iw list | egrep -A2 'interface combinations|Wiphy'.

This article has been tested on:

Owner name	NIC name	Vendor code	Device code	Comment
@foxpy	Intel Corporation Wi-Fi 6 AX200 (rev 1a)	8086	2723	Everything is OK, interface mode works parallel to station mode, wireshark prints sniffed packets in monitor mode
@foxpy	Intel Corporation Centrino Wireless-N 2200	8086	0891	Everything is OK, though I have noticed this older NIC outputs way more packets in monitor mode
@foxpy	ASUSTek Computer, Inc. 802.11ac NIC	0b05	184c	Some kernel threads hang after attempt to add monitor mode interface. Attempt to delete default station mode interface also hangs kernel. Driver for this NIC is cursed (I guess this NIC should be blacklisted)