Adding EGLO/AwoX Connect-C Sensor #39
Unanswered
AMDFreak2006
asked this question in
Q&A
Replies: 1 comment
-
|
Did you check if the sensor is recognized by the component? It should recognize it if the device is using the same mesh protocol. Will not be seen as a sensor but first step is to know if it's recognized at all. How does this device show up in the AwoX app? |
Beta Was this translation helpful? Give feedback.
0 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Uh oh!
There was an error while loading. Please reload this page.
-
Currently the library only supports lights but no sensors.
From Eglo there is (since many years) the Connect-C sensor click here which combines a motion detection sensor with a brightness sensors (like most motion detection sensors...) and the Eglo/Awox BLE-interface. I have it in use since many years and it works quite flawlessly. However the possible things one can do with it in the original Awox app are sadly very limited.
Would it be possible to add it to the library?
Which information are needed for integration? I will of course try to provide everything which is needed.
Beta Was this translation helpful? Give feedback.
All reactions