Reset model position when model changes

[furkandindar]

Hello,

I want to reset model position when a new model loads. Currently, if you rotate a model and then load a new model, newly loaded model is also rotated. You can check; https://joyous-plain-offer.glitch.me/ or simply open modelviewer editor load an astronaut model, rotate it around and load a horse model. Horse model is going to load with the astronaut model's rotation. Is there any way to reset this so newly loaded model renders properly?

[elalish]

Just call mv.cameraOrbit = "auto auto auto" in your "load" listener.

[furkandindar]

thanks for the answer! I was able to figure it out yesterday, but now I have another issue, I want to limit the maximum zoom-in functionality. When I try it on the Model Editor's min zoom section it sets min-camera-orbit="auto auto 0.5446m" min-field-of-view="20.94deg" and it works. But when the model loads into the scene I'm guessing min-camera-orbit="auto auto 0.5446m" radius (0.5446m) causes model to render further away from its original position. And if I delete the min-camera-orbit="auto auto 0.5446m" attribute, min-field-of-view="20.94deg" doesn't work at all. So I'm guessing I can't just use min-field-of-view to limit the zoom-in. can you help me with that?

[elalish]

Yes, the trouble is the radius; I think it'll work fine if you adjust 0.5446m to an equivalent e.g. 50%. That way when you load a differently-sized model, it will have a consistent relative zoom.

[furkandindar]

unfortunately changing radius to "50%" messes up the zoom-in functionality again..

[elalish]

Sorry, I didn't mean exactly 50%, but the appropriate % value to match the zoom-in that you want.

[furkandindar]

Thanks for the help, I think I'm close to figuring it out. appreciate it!