tread break detection for embroidery mode

[Ams-Laser]

can any one help me implement tread break detection for embroidery
tnks
Ed

[terjeio]

Both the physical detector and code to support it?

[terjeio]

When should the jump solenoid be deactivated? When the jump motion is completed?

[terjeio]

Here are some tentaive code changes, there are new settings for thread break input and jump solenoid output ports.
If the solenoid output port is set to -1 the mist output is used.
I am not able to test or debug these changes so you will have to do it.

embroidery.zip

[Ams-Laser]

When should the jump solenoid be deactivated? When the jump motion is completed?
here is a sample of the gcode im using for a single jump stitch

(jmp)
M3
M66 P1 L1 Q30
G00 X0.000 Y-5.200
M5
(jmp END)

it might be easyer to configure if we allow settings for gcode commands instead of hardcoding to certain outputs
something like:
JMP ON = M3
JMP OFF = M5

[Ams-Laser]

also note that the next movement after a needle change should be a jump stitch, also when a needle set command is encoutered a configurable output would be desired since either we need to pause for a manual change or we can use another axis motor to set the color changer position

[Ams-Laser]

Here are some tentaive code changes, there are new settings for thread break input and jump solenoid output ports. If the solenoid output port is set to -1 the mist output is used. I am not able to test or debug these changes so you will have to do it.

embroidery.zip

i cant get IDE to compile, can you please compile for me and send ? sorry for the hassle
Ed