Heishamon for F-Series HP #751
Replies: 4 comments 1 reply
-
|
Try to find out. Usually H series and later don't talk or spit any data to uart.. device needs to send request to it, and pump respons on request. So you get 0% because request is wrong or it's impossible to get that data via this port.. so it will be hard to get anything till you find device which talks with pump, and be able to capture it's traffic. |
Beta Was this translation helpful? Give feedback.
-
|
The board in my F-Series seems to be very talkative. If i compare the values (hex to dec) to my Webui (Panasonic HPM-800F22), they lineup. |
Beta Was this translation helpful? Give feedback.
-
|
I´m running a D-series and would also be happy about an implementantion of the older protocol. |
Beta Was this translation helpful? Give feedback.
-
|
My D-series reports on CN-NMODE port Wed Jan 21 21:25:31 2026 (1586365): Received bad header. Ignoring this data! looks like every 2 seconds as well |
Beta Was this translation helpful? Give feedback.
Uh oh!
There was an error while loading. Please reload this page.
-
We use a Panasonic WH-SXC09F3E8 with outdoor unit WH-UX09FE8.
Naturaly we get 0% valid packets via heishamon over CN-CNT or CN-NMODE port, because F-Series is not supported.
Is there a way to implement F-Series Heatpumps?
Or are F-Series communicating in a completely different way than the newer Series?
I could share captures from uart console, if needed.
Beta Was this translation helpful? Give feedback.
All reactions