Dyness battery supported?

[greymda]

Hey guys,
is Dyness (and conecutively Dyness BMS) supported by OpenDTU-OnBattery?
Example https://suministrosdelsol.com/en/dyness-batteries/892-dyness-b4850-48v-24kwh-lithium-battery.html

[AndreasBoehm]

Hey, the battery is compatible with victron inverters and our support for pytes batteries is also based on the victron protocol. Because of that i would assume that the battery can work with OpenDTU-OnBattery, but there is no guarantee until someone tried it or provides a CAN Protocol documentation from dyness.

[greymda]

if found this on internet, but don't know where exactly to look https://drive.google.com/file/d/1hSka8UvoSMR2WizIR3u58ZHuIAa3Q9Xh/view

[greymda]

and this https://solar.co.za/wp-content/uploads/2019/09/Dyness-Victron-inverter-Setup-startshut-down.pdf

[AndreasBoehm]

Based on this issue i assume that Dyness works exactly the same as a Pylontech battery: victronenergy/venus#913

[greymda]

thanks a lot, @AndreasBoehm!

[hokreb]

Did you try it already out with the dyness batteries? I have a system with 4 dyness b4850 and would also like to try this out, so any feedback is appriciated

[Charly-2]

Hi !
I use 2 DYNESS DL5.0c over CAN-Bus and it works without problems!