Trouble running the service

[cloudchaser11111]

After installing, when trying to run the relay I get following error :

strfry.service - strfry relay service
Loaded: loaded (/etc/systemd/system/strfry.service; enabled; preset: enabled)
Active: activating (auto-restart) (Result: exit-code) since Wed 2025-08-20 15:37:48 CEST; 2s ago
Process: 45907 ExecStart=/usr/local/bin/strfry relay (code=exited, status=127)
Main PID: 45907 (code=exited, status=127)
CPU: 19ms

aug 20 15:37:48 c### systemd[1]: strfry.service: Main process exited, code=exited, status=127/n/a
aug 20 15:37:48 c### systemd[1]: strfry.service: Failed with result 'exit-code'.

Anybody can point me in the right direction of solving this? Installed on Ubuntu 24.04, installation was without errors..

Thanks

[Michilis]

Exit code 127 usually means the binary can’t run or is failing very early. In most cases this happens because the LimitNOFILE value in your strfry config doesn’t match what the system supports. You can either lower it to a safe value (e.g. 65535) or raise your system’s limits so the higher value is accepted. Once adjusted, restart the service and it should start normally.