Manual target build issue

[UT3ULJ]

Hi, i'm trying to figure out how to build firmware by myself. I was followed the instruction in the docs and get working VSCode under WSL on Win10.
But can't make a build for f7 targets...it says there flash overflow.. Here is output with an error:

And in the same time MATEKF405 target is build succesfully... What i'm doing wrong?

[MrD-RC]

Have you made any code changes? The flash file is too big to fit on the F722. It’s using 119% of the available flash space.

[UT3ULJ]

Thanks for reply! No, i just download the repo from git and just trying to build the target... Maybe i should try to redownload it... but it's strange..

[UT3ULJ]

I found that if i just download the git repo and then try to build any target, everything works fine.

but when i folow the steps from this instruction (https://github.com/iNavFlight/inav/blob/master/docs/development/IDE%20-%20Visual%20Studio%20Code%20with%20Windows%2010.md) and trying build from VSCode, i'm start getting the error from the topic.. Maybe it's a build optimization level problem or something... I don't know where i can set it