ADC Channels 5 and 6

[dcan999]

Are these channels defined in INAV? Matek shows them on their INAV mapping, but when I connect battery voltage to VB2 I get no voltage reading, even when I tried to redefine the VB2 pin to ADC CH1. I want to use the VB2 and CU2 pads on my H743-Wlite to connect an external voltage/current sensor and have INAV use those values for current limiting and in the OSD. CLI only shows channels 1-4 available to swap. I know I can use the RSSI pad on CH3 for the 0-3.3v current output, but CH4 is 0-6.6v and the external current sensor vsense output is 0-3.3v. It would be nice to be able to use VB2/CU2 on ADC CH5 and CH6 and also this would allow two different battery voltage/currents to be shown on OSD.