esp d1 mini stop working when plugged in to ebus adapter v3

[frompani]

hi ,
I flashed ebus-v3_d1mini.bin on esp8266 -12f , and setup wifi with no issue.
But when I plug the esp into the adapter , esp does not connect to wifi .

Power cord and supply are good .
If I plug power into the adapter's usb nothing happen .
If I plug power into esp's usb , adapter's blue led start blinking ,green and orange are on, esp apparently not working .

any suggestion?
thnak's
fab

[john30]

mostly power source related, so try another one first.
and check if latest firmware is better as the WIFI signal strength was increased

[frompani]

already changed 3 . changed also esp ( twice) ... no luck . I'm trying to use a spare RPI . Eventually , could you sell a complete working system ( ebus+esp module )? thanks f Il giorno sab 17 set 2022 alle ore 09:03 John ***@***.***> ha scritto:

…

mostly power source related, so try another one first. and check if latest firmware is better as the WIFI signal strength was increased — Reply to this email directly, view it on GitHub <#69 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AQPCMXHJ2UOELW6VKVW4H5DV6VUNZANCNFSM52AAHX6Q> . You are receiving this because you authored the thread.Message ID: ***@***.***>

[john30]

did you do some fancy port setup on the esp through the command line interface or the web?

it works fine, I'm using a wifi variant myself, so the problem is elsewhere.

If I plug power into the adapter's usb nothing happen .

then you probably didn't do the jumpers correctly.