Error 501 Not Implemented

[Melonchanism]

When booting up the server, the tunnel creation causes a 501 error, and it also happens when trying to enable JIT

[joshrad-dev]

That usually means you have to send your pairing again.

[Melonchanism]

I tried resending the pairing file, creating a new pairing file, and checked that all the values were correct, but nothing changed.
When I go to http://[server ip]:8080/ , It says could not find any device.

[joshrad-dev]

Did you also do the refresh devices in the shortcut? That step also takes a little bit

[Melonchanism]

Yes, I have refreshed the tunnels, and I have tried everything several times. Using Clear Tunnels doesn't seem to do anything either.

[joshrad-dev]

Do you mind sending a screenshot of UTM when you’re doing this? I think that’ll help me figure out what’s wrong

[Melonchanism]

output.mov

[pengubow]

Having the same issue

This is first time opening the VM, I clicked send pairing and refresh tunnels

[Melonchanism]

My guess is that there are different versions of jitterbugpair that create different formats. I can send the pairing file that I was using after resetting trusted devices. Note that the added .txt is to let me upload it here.

00008120-0006098202B8C01E.mobiledevicepairing.txt

[EnderRobber101]

I have the same issue. Here is the shortcut response as i haven't seen that image so far.

[ksagameng2]

Happens to me with JitStreamer hosted on an android QEMU vm, it’s an issue with usbmuxd because if I start jitstreamer without starting usbmuxd the tunnel gets created (though I can’t enable jit)