Speed settings did not translate

[whyisjacob]

I set a print in Cura to have a speed setting of 50mm/s but when it got imported into AnkerMake it had a speed of well over 300mm/s

The speed estimate in Cura was about 20 hrs but when I changed the AnkerMake printer to really print at 50mm/s the new time estimate was over 122 hours

[just-trey]

@whyisjacob can you attach some sample gcode that does this so I can analyze it?

[whyisjacob]

@just-trey, Please see the attached google drive link https://drive.google.com/file/d/1j86MexU8W8_vhQs2SBj5JTNvfrmUy8vo/view?usp=share_link

[ravenium]

I had this happen to me today - rated speed says 625mm/s and 17 meters of filament. Cura is using the desired M5 profile.

Using https://www.printables.com/model/307366-StageTopDiceTower/files