EDAC/cell: Remove powerpc Cell driver

This driver can no longer be built since support for IBM Cell Blades was
removed, in particular PPC_CELL_COMMON.

Remove the driver.

  [ bp: Remove EDAC_CELL from Cell's defconfig too. ]

Signed-off-by: Michael Ellerman <[email protected]>
Signed-off-by: Borislav Petkov (AMD) <[email protected]>
Link: https://lore.kernel.org/r/[email protected]

Author: mpe

arch/powerpc/configs/cell_defconfig

@@ -168,7 +168,6 @@ CONFIG_INFINIBAND_MTHCA=m
 CONFIG_INFINIBAND_IPOIB=m
 CONFIG_INFINIBAND_IPOIB_DEBUG_DATA=y
 CONFIG_EDAC=y
-CONFIG_EDAC_CELL=y
 CONFIG_UIO=m
 CONFIG_EXT2_FS=y
 CONFIG_EXT4_FS=y

drivers/edac/Kconfig

@@ -303,14 +303,6 @@ config EDAC_PASEMI
 	  Support for error detection and correction on PA Semi
 	  PWRficient.
 
-config EDAC_CELL
-	tristate "Cell Broadband Engine memory controller"
-	depends on PPC_CELL_COMMON
-	help
-	  Support for error detection and correction on the
-	  Cell Broadband Engine internal memory controller
-	  on platform without a hypervisor
-
 config EDAC_CPC925
 	tristate "IBM CPC925 Memory Controller (PPC970FX)"
 	depends on PPC64

drivers/edac/Makefile

@@ -62,8 +62,6 @@ obj-$(CONFIG_EDAC_SKX)			+= skx_edac.o skx_edac_common.o
 i10nm_edac-y				:= i10nm_base.o
 obj-$(CONFIG_EDAC_I10NM)		+= i10nm_edac.o skx_edac_common.o
 
-obj-$(CONFIG_EDAC_CELL)			+= cell_edac.o
-
 obj-$(CONFIG_EDAC_HIGHBANK_MC)		+= highbank_mc_edac.o
 obj-$(CONFIG_EDAC_HIGHBANK_L2)		+= highbank_l2_edac.o