Merge branch 'net-iep-clock-module-fixes'

Meghana Malladi says:

====================
IEP clock module bug fixes

This series has some bug fixes for IEP module needed by PPS and
timesync operations.

Patch 1/2 fixes firmware load sequence to run all the firmwares
when either of the ethernet interfaces is up. Move all the code
common for firmware bringup under common functions.

Patch 2/2 fixes distorted PPS signal when the ethernet interfaces
are brough down and up. This patch also fixes enabling PPS signal
after bringing the interface up, without disabling PPS.
====================

Signed-off-by: David S. Miller <[email protected]>

Author: davem330

drivers/net/ethernet/ti/icssg/icss_iep.c

@@ -215,6 +215,9 @@ static void icss_iep_enable_shadow_mode(struct icss_iep *iep)
 	for (cmp = IEP_MIN_CMP; cmp < IEP_MAX_CMP; cmp++) {
 		regmap_update_bits(iep->map, ICSS_IEP_CMP_STAT_REG,
 				   IEP_CMP_STATUS(cmp), IEP_CMP_STATUS(cmp));
+
+		regmap_update_bits(iep->map, ICSS_IEP_CMP_CFG_REG,
+				   IEP_CMP_CFG_CMP_EN(cmp), 0);
 	}
 
 	/* enable reset counter on CMP0 event */
@@ -780,6 +783,11 @@ int icss_iep_exit(struct icss_iep *iep)
 	}
 	icss_iep_disable(iep);
 
+	if (iep->pps_enabled)
+		icss_iep_pps_enable(iep, false);
+	else if (iep->perout_enabled)
+		icss_iep_perout_enable(iep, NULL, false);
+
 	return 0;
 }
 EXPORT_SYMBOL_GPL(icss_iep_exit);

drivers/net/ethernet/ti/icssg/icssg_common.c

@@ -855,31 +855,6 @@ irqreturn_t prueth_rx_irq(int irq, void *dev_id)
 }
 EXPORT_SYMBOL_GPL(prueth_rx_irq);
 
-void prueth_emac_stop(struct prueth_emac *emac)
-{
-	struct prueth *prueth = emac->prueth;
-	int slice;
-
-	switch (emac->port_id) {
-	case PRUETH_PORT_MII0:
-		slice = ICSS_SLICE0;
-		break;
-	case PRUETH_PORT_MII1:
-		slice = ICSS_SLICE1;
-		break;
-	default:
-		netdev_err(emac->ndev, "invalid port\n");
-		return;
-	}
-
-	emac->fw_running = 0;
-	if (!emac->is_sr1)
-		rproc_shutdown(prueth->txpru[slice]);
-	rproc_shutdown(prueth->rtu[slice]);
-	rproc_shutdown(prueth->pru[slice]);
-}
-EXPORT_SYMBOL_GPL(prueth_emac_stop);
-
 void prueth_cleanup_tx_ts(struct prueth_emac *emac)
 {
 	int i;

drivers/net/ethernet/ti/icssg/icssg_config.c

@@ -397,7 +397,7 @@ static int prueth_emac_buffer_setup(struct prueth_emac *emac)
 	return 0;
 }
 
-static void icssg_init_emac_mode(struct prueth *prueth)
+void icssg_init_emac_mode(struct prueth *prueth)
 {
 	/* When the device is configured as a bridge and it is being brought
 	 * back to the emac mode, the host mac address has to be set as 0.
@@ -406,9 +406,6 @@ static void icssg_init_emac_mode(struct prueth *prueth)
 	int i;
 	u8 mac[ETH_ALEN] = { 0 };
 
-	if (prueth->emacs_initialized)
-		return;
-
 	/* Set VLAN TABLE address base */
 	regmap_update_bits(prueth->miig_rt, FDB_GEN_CFG1, SMEM_VLAN_OFFSET_MASK,
 			   addr <<  SMEM_VLAN_OFFSET);
@@ -423,15 +420,13 @@ static void icssg_init_emac_mode(struct prueth *prueth)
 	/* Clear host MAC address */
 	icssg_class_set_host_mac_addr(prueth->miig_rt, mac);
 }
+EXPORT_SYMBOL_GPL(icssg_init_emac_mode);
 
-static void icssg_init_fw_offload_mode(struct prueth *prueth)
+void icssg_init_fw_offload_mode(struct prueth *prueth)
 {
 	u32 addr = prueth->shram.pa + EMAC_ICSSG_SWITCH_DEFAULT_VLAN_TABLE_OFFSET;
 	int i;
 
-	if (prueth->emacs_initialized)
-		return;
-
 	/* Set VLAN TABLE address base */
 	regmap_update_bits(prueth->miig_rt, FDB_GEN_CFG1, SMEM_VLAN_OFFSET_MASK,
 			   addr <<  SMEM_VLAN_OFFSET);
@@ -448,18 +443,14 @@ static void icssg_init_fw_offload_mode(struct prueth *prueth)
 		icssg_class_set_host_mac_addr(prueth->miig_rt, prueth->hw_bridge_dev->dev_addr);
 	icssg_set_pvid(prueth, prueth->default_vlan, PRUETH_PORT_HOST);
 }
+EXPORT_SYMBOL_GPL(icssg_init_fw_offload_mode);
 
 int icssg_config(struct prueth *prueth, struct prueth_emac *emac, int slice)
 {
 	void __iomem *config = emac->dram.va + ICSSG_CONFIG_OFFSET;
 	struct icssg_flow_cfg __iomem *flow_cfg;
 	int ret;
 
-	if (prueth->is_switch_mode || prueth->is_hsr_offload_mode)
-		icssg_init_fw_offload_mode(prueth);
-	else
-		icssg_init_emac_mode(prueth);
-
 	memset_io(config, 0, TAS_GATE_MASK_LIST0);
 	icssg_miig_queues_init(prueth, slice);
 
@@ -786,3 +777,27 @@ void icssg_set_pvid(struct prueth *prueth, u8 vid, u8 port)
 		writel(pvid, prueth->shram.va + EMAC_ICSSG_SWITCH_PORT0_DEFAULT_VLAN_OFFSET);
 }
 EXPORT_SYMBOL_GPL(icssg_set_pvid);
+
+int emac_fdb_flow_id_updated(struct prueth_emac *emac)
+{
+	struct mgmt_cmd_rsp fdb_cmd_rsp = { 0 };
+	int slice = prueth_emac_slice(emac);
+	struct mgmt_cmd fdb_cmd = { 0 };
+	int ret;
+
+	fdb_cmd.header = ICSSG_FW_MGMT_CMD_HEADER;
+	fdb_cmd.type   = ICSSG_FW_MGMT_FDB_CMD_TYPE_RX_FLOW;
+	fdb_cmd.seqnum = ++(emac->prueth->icssg_hwcmdseq);
+	fdb_cmd.param  = 0;
+
+	fdb_cmd.param |= (slice << 4);
+	fdb_cmd.cmd_args[0] = 0;
+
+	ret = icssg_send_fdb_msg(emac, &fdb_cmd, &fdb_cmd_rsp);
+	if (ret)
+		return ret;
+
+	WARN_ON(fdb_cmd.seqnum != fdb_cmd_rsp.seqnum);
+	return fdb_cmd_rsp.status == 1 ? 0 : -EINVAL;
+}
+EXPORT_SYMBOL_GPL(emac_fdb_flow_id_updated);

drivers/net/ethernet/ti/icssg/icssg_config.h

@@ -55,6 +55,7 @@ struct icssg_rxq_ctx {
 #define ICSSG_FW_MGMT_FDB_CMD_TYPE	0x03
 #define ICSSG_FW_MGMT_CMD_TYPE		0x04
 #define ICSSG_FW_MGMT_PKT		0x80000000
+#define ICSSG_FW_MGMT_FDB_CMD_TYPE_RX_FLOW	0x05
 
 struct icssg_r30_cmd {
 	u32 cmd[4];