LTXVAudioVideoMask

[RuneGjerde]

Trying some of your LTX nodes to figure out what is what ;-)

Most of them are self-explanatory, and well, so is LTXVAudioVideoMask

But struggling a bit to make it work in all scenarios.
Currently I can use it with a start at end of input video, and use it to extend the video. Works well.
Or use it to "retake" (change) some of the input video, but it only seems to work of the end is set to end of input video (or after end).
If trying to change the middle of the video, i dont get good results

Any trick to make it work within a video? or perhaps not intended that way (but since it says video start and video end, and LTX-2 has a ReTake feature on their site, i guess it might work)

https://docs.ltx.video/api-documentation/api-reference/video-generation/retake

Although i did see some new info at that link:
"Duration in seconds, defines the duration of the section to be edited in the input video. Must be at least 2 seconds. "

Maybe i tried too short of a change range, but think i did more than 2 seconds...

[kijai]

I know this isn't really named correctly as truncate doesn't actually truncate, I'll probably change that and add new mode, but for now it should do what you want, and also there is a node to preview latent masks so you can see for yourself:

[RuneGjerde]

ah nice ;-) will try that

[kijai]

Actually already did that so it's clearer:

Truncate will now properly cut to the end time:

And partial is the old behavior where it just masks the range:

You can also chain the nodes:

In the end it's just latent noise masks, the node is just helping to keep video and audio in sync as the masks are bit differently timed.

[RuneGjerde]

Ah yes, that naming seems more intuitive ;-) nice. Will update the nodes and try it out

Chain the nodes, that can for sure do some creative stuff ;-)