With only one group unable to add additional "Unmonitored" thermostats.

[pforte]

With only a single group you cannot add an additional thermostat to that group. The drop down menu "select a group" does not provide the selection of the single group.

Steps:

1. Created a group "1st Floor" and added the "Office".
2. Selected "Unmonitored" and selected "Living Room" to add to group.
3. Dialog box appears asking to "select a group" or "Create new group"
4. Drop down menu of "select a group does not show my single "1st Floor" group.

[kneave]

If you select an unmonitored entity and first click monitor, themn use setting for that group to move the entity does it let you?

[kneave]

Is this still an issue?

[pforte]

Hello. I gave that a try and got the same results.
Steps:

1. Selected an unmonitored entity and first click monitor. Climate Scheduler creates a new Monitored device (Living Room Mitsubishi Thermostat).
2. Go to the member entity to move it to the intended Monitored Group (First Floor).
3. Dialog Box "add to group" opens. Select to group drop-down menu has no list to select.

The results are the same. I'm unable to add a member entity to "1st Floor" group.

[kneave]

Ooh, I just noticed the likely issue and confirmed it! Your other schedule is disabled and it looks like only enabled groups are listed in that drop down! I can fix this for sure, easy work around in the interim is to enable the schedule to add the entity and then disable afterwards if needed.

[kneave]

I've put a fix in place, it'll be included in the next release

[pforte]

I believe that was my issue. The group I wanted to add the additional thermostat was disabled. When a group is disabled it will not show up on the drop down list. Once I enabled the group, it showed up on the drop-down list.