ata: libata: Print if port is external on boot

Commit affccb1 ("ata: ahci: print the lpm policy on boot") added a
lpm-pol print during boot, which shows the LPM policy used by each port.

While the LPM policy is usually determined by the Kconfig
CONFIG_SATA_MOBILE_LPM_POLICY, the Kconfig value is overridden e.g. if
firmware has marked the port as hotplug capable / external.

Commit f97106b ("ata: ahci: Add debug print for external port") did
add a debug print to show if LPM was disabled because firmware has marked
the port as external, however, because devices having broken LPM (even
though they claim to support it) is more common than one would have hoped,
print "ext" during boot if firmware has marked the port is external.

This will make it easier to debug certain LPM issues, e.g. if firmware has
enabled/marked only some of the ports as hotplug capable / external.

Before (port marked as external by firmware):
ata1: SATA max UDMA/133 abar m4096@0xfebd3000 port 0xfebd3100 irq 57 lpm-pol 0

After (port marked as external by firmware):
ata1: SATA max UDMA/133 abar m4096@0xfebd3000 port 0xfebd3100 irq 57 lpm-pol 0 ext

Signed-off-by: Niklas Cassel <[email protected]>
Signed-off-by: Damien Le Moal <[email protected]>

Author: floatious

include/linux/libata.h

@@ -1618,6 +1618,8 @@ static inline void ata_port_desc_misc(struct ata_port *ap, int irq)
 {
 	ata_port_desc(ap, "irq %d", irq);
 	ata_port_desc(ap, "lpm-pol %d", ap->target_lpm_policy);
+	if (ap->pflags & ATA_PFLAG_EXTERNAL)
+		ata_port_desc(ap, "ext");
 }
 
 static inline bool ata_tag_internal(unsigned int tag)