Support for OLimex Lime 2 [Documentation Feature] #297
Description
Hello everyone,
I hope this finds you in the absolute best of health.
I am writing this issue request in hopes to provide documentation for flashing using the Lime2 board by Olimex [1]. I am still a bit newer to BIOS flashing but confident I can help contribute.
My assumption is that in order to flash users would need the A20-OLinuXino-LIME2-UEXT, LIME GPIO2 LCD STEP ADAPTER however I could be wrong.
Would it be correct in stating that I should just transliterate the RPI pins?
| Pin Number | Clip (25xx signal) | Raspberry Pi | OLimex Lime 2 |
|---|---|---|---|
| 1 | CS | 24 | uncertain |
| 2 | MISO | 21 | 39 |
| 3 | not used | not used | not used |
| 4 | GND | 25 | 2 |
| 5 | MOSI | 19 | 37 |
| 6 | CLK | 23 | 31 |
| 7 | not used | not used | not used |
| 8 | 3.3V | 3 |
Thank you so much for any help you can provide. As well as for helping create such a wonderful project.