Calibration of mHM

[9202014710]

I wanna to know how to perform automatic calibration of the model? I remember the introduction mentioned that there are several methods can be used, but I don't know how to call the specific method. I want to adjust the parameters when I have the actual measurement results.

[9202014710]

I just read the manual again and found the parameters of the calibration setting, but why did the following error appear when executing.

[9202014710]

mhm_nml.txt
Here is the namelist file (I changed the suffix for uploading). I just modified optimize from FALSE to TRUE for calibration, but error occurred.

[9202014710]

After my continuous debugging, I finally know what the problem is, and it is now running successfully!!!
I have modified the optimization method, the first method (DDS) would run an error, after the modification, it seems to be normal at present, and the process is still being determined. This process seems to be time-consuming and has not yet ended.

[9202014710]

After my test, now I have successfully run the DDS and SCE methods, and the effect is good.

But why SCE methods often report errors?

The MCMC method is still not available.
The SA method can be used, but it is very time-consuming and takes more than 12 hours to complete the calculation. Is there any optimization method?

1. There is a question: What should I do if I want to rate multiple floods in the same basin to get a comprehensive optimal parameter combination? At present, only one process can be calibrated, and the combination of parameters calibrated may lack certain representativeness.

2. At the same time, I want to know why mhm_mpi does not execute correctly.