Is DSM6.1.7 OK?

[ihongyi]

Can this support Synology? I haven't succeeded in DSM6.1.7. Can I ask you the way?

[michaelroland]

This software is specific to Western Digital My Cloud DLx100 and PRx100 device hardware. It would not make any sense on other platforms.

[ihongyi]

My hardware is pr4100.
The system is Synology
The system could not find the systemctl command.

[ihongyi]

I only found the synoservice command.

Run sudo synoservice -is-enable wdhwd.service

Prompt Service [wdhwd.service] does not exist

[ihongyi]

synoservice -help
--help Show this help
--help-dev More specialty functions for deveplopment
--is-enabled [ServiceName] Check if the service is enabled
--status [ServiceName] Get the status of specified services
--enable [ServiceName] Set runkey to yes and start the service (alias to --start)
--disable [ServiceName] Set runkey to no and stop the service (alias to --stop)
--hard-enable [ServiceName] Set runkey to yes and start the service and its dependency (alias to --hard-start)
--hard-disable [ServiceName] Set runkey to no and stop the service and its dependency (alias to --hard-stop)
--restart [ServiceName] Restart the given service
--reload [ServiceName] Reload the given service
--pause [ServiceName] Pause the given service
--resume [ServiceName] Resume the given service
--pause-by-reason [ServiceName] [Reason] Pause the service by given reason
--resume-by-reason [ServiceName] [Reason] Resume the service by given reason
--pause-all (-p) [Reason] (Event) Pause all service by given reason with optional event(use -p to include packages)
--pause-all-no-action (-p) [Reason] (Event) Set all service runkey to no but leave the current service status(use -p to include packages)
--resume-all (-p) [Reason] Resume all service by given reason(use -p to include packages)
--reload-by-type [type] (buffer) Reload services with specified type
--restart-by-type [type] (buffer) Restart services with specified type
Type may be {file_protocol|application}
Sleep $buffer seconds before exec the command (default is 0)

[stefaang]

You need to make a synology service file.
Are you able to run the service directly?

python -m wdhwdaemon.daemon

Do you have instructions to setup DSM on PR4100? Then I can have a look.

[ihongyi]

python -m wdhwdaemon.daemon Can run What is missing from the plugin
setup DSM on PR4100 You need to install DSM boot on the USB
Can refer to https://xpenology.com/forum/forum/31-loaders/

[ihongyi]

synology.txt
This is the command I exported.

[stefaang]

I flashed the 6.2 loader to a USB drive but it didn't find the PR4100 device via find.synology.com.
Please provide more detailed setup instructions if possible.

The service file is made for systemd, you need to create your own service file to match the synoservice spec. Just look at other services for examples.

[ihongyi]

Thank you very much for your reply
Can you find the ip address of pr4100 through the router?
Have you modified the vid, pid, and sn of the grub file in the 6.2 loader?
If there is no sn, I can provide it to you.
Sorry, my lack of knowledge about linux