arm64: dts: imx8-ss-conn: fix usb lpcg indices

usb2_lpcg: clock-controller@5b270000 {
	...                                                    Col1  Col2
	clocks = <&conn_ahb_clk>, <&conn_ipg_clk>;           // 0     6
	clock-indices = <IMX_LPCG_CLK_6>, <IMX_LPCG_CLK_7>;  // 0     7
        ...
};

Col1: index, which existing dts try to get.
Col2: actual index in lpcg driver.

usbotg1: usb@5b0d0000 {
	...
	clocks = <&usb2_lpcg 0>;
			     ^^
Should be:
	clocks = <&usb2_lpcg IMX_LPCG_CLK_6>;
};

usbphy1: usbphy@5b100000 {
	clocks = <&usb2_lpcg 1>;
			     ^^
SHould be:
	clocks = <&usb2_lpcg IMX_LPCG_CLK_7>;
};

Arg0 is divided by 4 in lpcg driver. So lpcg will do dummy enable. Fix it
by use correct clock indices.

Cc: [email protected]
Fixes: 8065fc9 ("arm64: dts: imx8dxl: add usb1 and usb2 support")
Signed-off-by: Frank Li <[email protected]>
Signed-off-by: Shawn Guo <[email protected]>

Author: nxpfrankli

arch/arm64/boot/dts/freescale/imx8-ss-conn.dtsi

@@ -41,7 +41,7 @@ conn_subsys: bus@5b000000 {
 		interrupts = <GIC_SPI 267 IRQ_TYPE_LEVEL_HIGH>;
 		fsl,usbphy = <&usbphy1>;
 		fsl,usbmisc = <&usbmisc1 0>;
-		clocks = <&usb2_lpcg 0>;
+		clocks = <&usb2_lpcg IMX_LPCG_CLK_6>;
 		ahb-burst-config = <0x0>;
 		tx-burst-size-dword = <0x10>;
 		rx-burst-size-dword = <0x10>;
@@ -58,7 +58,7 @@ conn_subsys: bus@5b000000 {
 	usbphy1: usbphy@5b100000 {
 		compatible = "fsl,imx7ulp-usbphy";
 		reg = <0x5b100000 0x1000>;
-		clocks = <&usb2_lpcg 1>;
+		clocks = <&usb2_lpcg IMX_LPCG_CLK_7>;
 		power-domains = <&pd IMX_SC_R_USB_0_PHY>;
 		status = "disabled";
 	};