Changing settings under "comfort profiles" does not change the settings on the actual system

[compilebunny]

I am using the docker image with manifest digest sha256:5761aba9b6282bbff315ad2da9770be3a30f99efea441a19515df13544773825 on a Raspberry Pi. The HVAC system in question has only a furnace and has one zone.

When I first set the system up about 2 weeks ago, I confirmed that changing the settings under "comfort profiles" changed the actual state of the furnace.

Today, that does not seem to be the case. I can see the temperature and temperature setpoint, but nothing updates when I make changes to the "comfort profiles" page and click "save". The "comfort profiles" page remembers what I enter, but nothing updates on the "status" page.

The top of the status page says "System settings updated Mon 2025-11-03 at 4:06AM", which corresponds approximately to when I first set up the docker image.

How do I change the actual state of the heating system?

Note that I am not using the Carrier app. I think* that the furnace control should be communicating only with the infinitude docker instance.

Edit: There is an info message present now that was not present when on 11/3 (when the system claims that the configuration was last updated):
[2025-11-17 21:58:02.20263] [7] [info] Websocket opened, but no streaming source is configured

[github-actions]

This issue has not been active in a while. It will be automatically closed soon absent further activity.

[nebulous]

The websocket log message is benign - that just says a serial device wasn't detected.

Regarding the state issues, do you see the thermostat calling infinitude in the logs? What does your state folder look like?