Best way/how to do the hardware wiring?

[fishbonegaminglabs]

First time I soldered the wires to reflash the radio, but I find this a bit complicated to do it over and over again.
I do have soldering skills, but those pads will eventually go bad, so what is the best way to connect it?

Making a clip on connector could work?

[nepeee]

It is a passible solution to port the Arduino flasher code(https://github.com/fishpepper/CC2510Lib) to the tinyhawk stm32f4xx. Than we can make a permanent mod(connecting some pads) and use the Betaflight Configurator to flash our flasher software for rx fw updates.

For now you can solder some wire wrap(thin) wires to the pads and use a 2.54mm (0.1inch) pin header.
https://en.wikipedia.org/wiki/Pin_header