[nrf fromlist] soc: nordic: common: poweroff: Set VPR to remain in its reset state

CM33 must write MEMCONF.POWER[VPR].RET = 0 before entering System OFF.
This bit drives the vprSavedCtx input to VPR. Forcing it low will
disable the Hibernate wake feature in VPR, so that VPR will remain
in its reset state when waking from OFF.

Upstream PR #:88760

Signed-off-by: Jakub Zymelka <[email protected]>

Author: jaz1-nordic

soc/nordic/common/poweroff.c

@@ -16,12 +16,18 @@
 #endif
 #if defined(CONFIG_SOC_SERIES_NRF54LX)
 #include <helpers/nrfx_reset_reason.h>
+#include <hal/nrf_memconf.h>
 #endif
 
 #if defined(CONFIG_HAS_NORDIC_RAM_CTRL)
 #include <helpers/nrfx_ram_ctrl.h>
 #endif
 
+#if defined(CONFIG_SOC_SERIES_NRF54LX)
+#define VPR_POWER_IDX 1
+#define VPR_RET_BIT   MEMCONF_POWER_RET_MEM0_Pos
+#endif
+
 void z_sys_poweroff(void)
 {
 #if defined(CONFIG_HAS_NORDIC_RAM_CTRL)
@@ -59,6 +65,9 @@ void z_sys_poweroff(void)
 #endif
 
 #if defined(CONFIG_SOC_SERIES_NRF54LX)
+	/* Set VPR to remain in its reset state when waking from OFF */
+	nrf_memconf_ramblock_ret_enable_set(NRF_MEMCONF, VPR_POWER_IDX, VPR_RET_BIT, false);
+
 	nrfx_reset_reason_clear(UINT32_MAX);
 #endif
 #if defined(CONFIG_SOC_SERIES_NRF51X) || defined(CONFIG_SOC_SERIES_NRF52X)