lo-pro bottom doesn't seem to fit.

[mboedigh]

I printed the lo-pro bottom based on the stl file. I noticed the R6 PCB fits almost flush with the top of the lo-pro which means there will be a gap between the lo-pro bottom and the MX plate. Does that sound right? Am I missing a piece?

[mboedigh]

This is an old STL (approx June 2018) file that has offsets built into the base. The new Rev6 PCB has its own offsets so the ones the base aren't needed. I tapped both the long pegs, that are used to attach the key plate, and the short standoffs. Then I trimmed the short standoffs flush with the bottom, and the PCB fit fine. I tapped the standoffs deep enough to almost go through the bottom and screwed the PCB into the base from the top. Seems to work, but a more secure solution might be to tap all the way through the base and screw the PCB in from the bottom of the case.