You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
In case no suitable load is available, the current approach can be used, that the charging station is connected somewhere in the grid
In case a suitable load can be found, the charging point should be connected directly to the same bus as the load
A load is only suitable, if number of connected charging points is below defined value as done here
Connecting to a suitable load bus could also be made an option when calling the function
Same can be done for heat pumps, storage units and generators
Heat pumps with sector 'individual_heating' or 'individual_heating_resistive_heater' should be connected to some load bus
Solar generators in those voltage levels should be connected to some load bus
Storage should be connected to bus with a solar generator
Same could be done for voltage level 6
Same could also be done in MV, but here, the distance from the geolocation of the component to the selected bus should not be too large; in case it is too large, the component should just be connected based on its geolaction
Charging points public - if next grid connection point in LV is too far away, check whether next grid connection option in MV is much closer
Consider distance from grid in attractivity of public charging points - @khelfen could you please add here where best to do it? I think here, but I don't fully understand this function. Maybe elaborating the docstring would help.
