Behavior of "autotrim=on" vs "zpool trim" when disks lack TRIM support​

[yuanfangcc]

I have a question regarding the difference in behavior between the zpool trim command and setting the autotrim pool property when dealing with disks that do not support the TRIM function.

From my observation and testing, the zpool trim command actively checks if the underlying disks support TRIM operations. If a disk does not support TRIM, the command fails gracefully and does not attempt the operation (e.g., displaying errors like "trim operations are not supported by this device").

However, it seems that setting the autotrim=on property using zpool set autotrim=on does not perform the same validation check. This leads to my concern:

​​If autotrim=on is enabled on a pool containing disks that do not actually support TRIM, what is the expected behavior?​​

Thank you for your insights and time.

[IvanVolosyuk]

I have a HDD only pool which has auto trim enabled by mistake without any issues. I had a pool where there was a mix of special SSDs and HDDs - there is no property to apply trim to SSDs only, so kinda reasonable compromise.

…

On Wed, Sep 3, 2025, 17:56 cabaneri ***@***.***> wrote: I have a question regarding the difference in behavior between the zpool trimcommand and setting the autotrimpool property when dealing with disks that do not support the TRIM function. From my observation and testing, the zpool trimcommand actively checks if the underlying disks support TRIM operations. If a disk does not support TRIM, the command fails gracefully and does not attempt the operation (e.g., displaying errors like "trim operations are not supported by this device"). However, it seems that setting the autotrim=onproperty using zpool set autotrim=ondoes not perform the same validation check. This leads to my concern: ​​If autotrim=onis enabled on a pool containing disks that do not actually support TRIM, what is the expected behavior?​​ Thank you for your insights and time. — Reply to this email directly, view it on GitHub <#17694>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ABXQ6HN2KTKEDTDYTDL3X7D3Q2NJ7AVCNFSM6AAAAACFPWD5YOVHI2DSMVQWIX3LMV43ERDJONRXK43TNFXW4OZYHAZTIMZVGA> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>